Abstract
A radiation hard micro-strip sensor for the use in the Upgrade of the strip tracker of the ATLAS experiment at the High Luminosity Large Hadron Collider (HL-LHC) has been developed by the "ATLAS ITk Strip Sensor collaboration" and produced by Hamamatsu Photonics. Surface properties of different types of end-cap and barrel miniature sensors of the latest sensor design ATLASI2 have been studied before and after irradiation.
The tested barrel sensors vary in "punch-through protection" (PTP) structure, and the end-cap sensors, whose stereo-strips differ in fan geometry, in strip pitch and in edge strip ganging options. Sensors have been irradiated with proton fluences of up to 1 x 10(16) n(eq)/cm(2), by reactor neutron fluence of 1 x 10(15) n(eq)/cm(2) and by gamma rays from Co-60 up to dose of 1 MGy.
The main goal of the present study is to characterize the leakage current for micro discharge breakdown voltage estimation, the inter-strip resistance and capacitance, the bias resistance and the effectiveness of PTP structures as a function of bias voltage and fluence. It has been verified that the ATLASI2 sensors have high breakdown voltage well above the operational voltage which implies that different geometries of sensors do not influence their stability.
The inter-strip isolation is a strong function of irradiation fluence, however the sensor performance is acceptable in the expected range for HL-LHC. New gated PTP structure exhibits low PTP onset voltage and sharp cut-off of effective resistance even at the highest tested radiation fluence.
The inter-strip capacitance complies with the technical specification required before irradiation and no radiation-induced degradation was observed. A summary of ATLASI2 sensors tests is presented including a comparison of results from different irradiation sites.
The measured characteristics are compared with the previous prototype of the sensor design, ATLAS07.