Abstract
Magnesium alloys based on Nd and Zn are promising materials for both aviation industry and medical applications. Superior mechanical properties of these materials can be achieved by thermomechanical processing such as extrusion or rolling and by aging treatment, which can significantly strengthen the alloy.
The question remains especially about the connection of texture strength created in the alloys based on the specific conditions of preparation. This work focuses on the Mg-3Nd-0.5Zn magnesium alloy prepared by hot extrusion of the as-cast state at two different temperatures combined with heat pre-treatment.
Extrusion ratio of 16 and rate of 0.2 mm/s at 350 and 400 degrees C were selected for material preparation. The structures of prepared materials were studied by scanning electron microscopy and transmission electron microscopy.
The effect of microstructure on mechanical properties was evaluated. Obtained results revealed the strong effect of thermal pre-treatment on final microstructure and mechanical properties of extruded materials.
The Hall-Petch relation between grain size and tensile yield strength has been suggested in this paper based on the literature review and presented data. The observed behavior strongly supports the fact that the Hall-Petch of extruded Mg-3Nd-0.5Zn alloys with different texture intensities cannot be clearly estimated and predicted.
In addition, Hall-Petch relations presented in literature can be sufficiently obtained only for fraction of the Mg-3Nd-0.5Zn alloys.